| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Making the ES335 Neck Tennon. http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=40841 |
Page 1 of 1 |
| Author: | Harold_Donn [ Tue Jul 09, 2013 3:58 pm ] |
| Post subject: | Making the ES335 Neck Tennon. |
I'm almost done with my first ES335. Making the tennon for the neck was quite a challenge for me. I managed it but just barely  I was wondering if anyone had some good tips for cutting a nice straight, or angled in this case, tennon that fits up flat against the body just right. I'm not picky. Any suggestions large or small would be welcome Thanks. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|